3 PressNUMBER buttons to input the re-
gisteredcode number.
4 Clickthe joystick.
Thisenters the code number, and you can now
changethe level.
#Ifyou input an incorrect code number, the
icon isdisplayed. Press CLEAR and input the
correctcode number.
#Ifyou forget your code number, refer to If you
forgetyour code number on this page.
5 Movethe joystick left or right to select
thedesired level.
6 Clickthe joystick.
Theparental lock level is set.
Note
PressingRETURN takes you back to the previous
display.

If you forget your code number

Referto Changing the level on the previous
page,and press CLEAR 10 times. The regis-
teredcode number is canceled, letting you
registera new one.
Automatic playback of DVDs
Whena DVDs disc with DVD menu is inserted,
thisunit will cancel the DVD menu automati-
callyand start playback from the first chapter
ofthe first title.
!SomeDVDs may not operate properly. If
thisfunction is not fully operated, turn this
functionoff and start playback.
1 Movethe joystick up or down to select
DVDAUTO PLAY in the
SET-UPMENU (GEN).
DVDAUTO PLAY is highlighted.
2 Clickthe joystick to turn automatic
playbackon or off.
#Whenthe automatic playback is on, you can-
notoperate repeating play of DVD disc (refer to
Repeatingplay on page 27).
Setting remote controlcode type
Whenthe remote control operation switch is
setto DVD, changing the remote control code
typeenables you to operate the Pioneer DVD
playerby the supplied remote control. There
arethree remote codes, code type A, code
typeBand code type DVH. When using this
unitwith a multi-DVD player (e.g. XDV-P9), se-
lectcode A. When using this unit only, select
codeDVH.
!Withthis unit, code Bcannot be used.
1 Setthe remote control selection switch
onthe left side of the remote control to
theappropriate position with a pen tip or
otherpointed instrument .
!Ifyou select DVH mode, there is no need to
takethe following procedure.
!Ifyou select A/Bmode, take the following
procedureand change the code type to the
appropriatetype.
2 Press7 and 0 on the remote control si-
multaneouslyto change the code type.
Initially,the code type is set to A. Each time
youpress 7and 0simultaneously on the re-
motecontrol the code type switches between
AandB.
Setting up the DVD player
En
80
Section
13