Installing the 6400-S
•Rating: For U.S./Canada cords must be UL Listed/CSA Certified type SJT, 18-3 AWG. For outside U.S./Canada cords must be flexible harmonized (<HAR>) or VDE certified cord with 3 x 0.75 mm conductors rated 250 VAC.
•Connector, wall outlet end: Cords must be terminated in grounding-type male plug designed for use in your region. The connector must have certification marks showing certification by an agency acceptable in your region and for U.S. must be Listed and rated 125% of overall current rating of the 6400-S.
•Connector, 6400-S end: The connectors that plug into the AC receptacle on the 6400-S must be an approved IEC 320, sheet C19, type female connector.
•Cord length and flexibility: Cords must be less than 4.5 meters (14.76 feet)
long. CAUTION Temperature: The temperature in which the 6400-S operates when installed in an equipment rack, must not go below 5 °C (41 °F) or rise above 40 °C (104 °F). Extreme fluctuations in temperature can cause a variety of problems in your 6400-S.
•Ventilation: The equipment rack must provide sufficient airflow to the front of the 6400-S to maintain proper cooling. The rack must also include ventilation sufficient to exhaust a maximum of 1023 BTU's per hour for the 6400-S. The rack selected and the ventilation provided must be suitable to the environment in which the 6400-S will be used.
Power Supplies1
The power supply cage shown is accessed from the rear of the chassis. The power supply cage supports up to two hot-swap power supplies (either AC input or DC input) in a (1+1) redundant configuration. Only the DC input version is NEBS certified. The combined output power to the 6400-S system is 470 Watts per DC supply and 500 Watts per AC supply.
DC Power Supply Interface Requirements
The DC power source may produce hazardous voltage levels exceeding -60 VDC and high energy levels above 240VA that may cause electric shock or burns. All DC input connections should be made only by a qualified service person to prevent injury. All wiring terminals connected to the DC input terminal block must be fully insulated with no exposed bare metal.
The power supply will operate within all specified limits over the input voltage range outlined as follows:
1 Intel® Telco/Industrial Grade Server TIGPR2U Product Guide
