Polycom MGC-50/MGC-100 Connecting the MGC-50 to the IP Network, LAN IP network connection

MGC Hardware and Installation Manual

Connecting the MGC-50 to the IP Network

If an IP network Interface card is installed in the MGC, connect the 8-pin RJ-45 connector of the LAN network cable to the LAN-323 RJ-45 jack on the rear panel of the MGC.

Figure 2-17: LAN IP network connection

The IP network properties must be defined in the IP Network Service. For details, see MGC Administrator’s Guide, Chapter 3.

2-31