Viewing the Hour Meter
HOURS appears on the display followed by the number of hours that the unit has been in use. The treadmill tracks the elapsed minutes, but the value that appears is truncated to the nearest full hour.
3.When you are ready, press SELECT to move to the next display (software version).
Viewing the Software Version and Part Numbers
UPPER SW scrolls across the display followed by the upper board application software part number and version (for example,
4.To see the upper boot and lower board application software version, press the SELECT key. If needed, you can move through all
5.Write the numbers below. You will need these numbers when you call Customer Support with
Upper Software P/N: _____________
Lower Software P/N: ___________________
Upper Boot Application P/N: ___________________
6.When you are ready, press the red STOP button or RESET to move to the next display (error log).
Viewing the Error Log
The first error log entry scrolls across the display. Up to ten error codes can be retrieved. If there are no errors in the log, you will see NO ERRORS displayed.
7.To view any additional error codes in the error log, use the arrow keys. Each error code specifies when it occurred, listing the odometer and hour meter values. Refer to Diagram 7.
Most recent error | The hour meter at the time the error |
| was detected. |
1: ER33 AT 12,345,678 MILES 1,714 HOURS
Error code | Odometer reading at the |
| time the error occurred. |
Diagram 7: Error log
8.Copy the error code information to paper so you can provide it to Customer Support if needed. Be sure to copy it exactly as shown.
9.When you no longer need the information in the error log, press QUICKSTART for at least four seconds to erase the error log. Continue to maintain light pressure on the key until the message OK appears. When the key is released, NO ERRORS appears on the display, which indicates the error log has been deleted.
Important: You cannot retrieve the error log once you have deleted it. You may want to resolve any issues you are experiencing with the treadmill before clearing the error log.
10.When you are ready, press SELECT, RESET, or the STOP button to return to the Precor banner.
Product Owner’s Manual: Club Features | 15 |
