Assembly Steps

Remove the hood and set it aside.

Use a ¼-inch hex key and ½-inch box end wrench to remove the four shipping fasteners on the front panel.

Discard the nuts, but keep the screws.

Note: The front panel will drop slightly when you remove the fasteners.

Remove any tape or wire ties that secure the display cable. Unwrap the cable and remove the kinks.

Ask your assistant to hold the display console in place while you attach it to the left upright support using two buttonhead screws (A) and two washers (B).

Place the left side upright support into the base frame side bracket. Secure the upright support to the side bracket using two socket head screws (C), two washers (E), and two barrel spacers (F). Secure the upright to the front panel using two screws removed in step 2 and two washers (B) from the hardware kit. Finger tighten.

Commercial Treadmill Assembly Guide

4

Page 62
Image 62
Precor C952i, C966i owner manual Assembly Steps