Printek 4000se manual Unload / Form

D A I L Y O P E R A T I O N

UNLOAD / FORM	If paper is currently loaded (no paper out
SELECT	condition exists), this button unloads the paper
	and places the top edge of the paper in the
	tractors in the base of the unit. This allows you to
	change the paper easily. A paper out condition is
	displayed to indicate that the paper was unloaded
	successfully.
	The printer will attempt to unload up to 36
	inches of paper. If the top edge of the paper is
	not found, paper motion will stop and “Too
	Much Paper” will be displayed on the LCD
	display. Normally, previous pages should be torn
	off before you press UNLOAD. It is
	recommended that you not use this method to
	unload more than the current form.
	When no paper or form is currently loaded, this
	button selects one of ten preset form setups. In
	the FormsPro 4503se, this may also select a
	different set of tractors to be used the next time
	you press the LOAD button.
	The printer will not allow you to change the form
	during printing. If you press the FORM SELECT
	button while there is still a line to print, the button
	press is rejected, the bell sounds, and the
	message “Finish Printing!” flashes on
	the LCD display. If this happens, you should
	place the printer back on-line, allow the form to
	finish printing, and then place the printer off-line
	and select the desired new form. If you press
	and hold this button at power-up/reset on the
	FormsPro 4503se, and paper has not been
	loaded, the tractor shuttle moves all the way
	forward to its parked position.
	Note: The tractor shuttle should always be
	parked and secured whenever the printer is
	being transported.

23