D A I L Y O P E R A T I O N
Continue to press the UNLOAD/FORM SELECT button until the desired form name is shown on the top line of the display. When the desired form is displayed press the LOAD/FORM FEED button. The form name will be FORM 0 through FORM 9 or the actual name of the form if the name has been set in Setup. If the desired form is not considered to be “loaded” by the printer, <Not Loaded> will flash on the bottom line of the display. In the case of the FormsPro 4503se the Not Loaded message will alternate with the path(s) that this form is to be loaded in.
Changing the Form in the Tractors
1.To unload the currently loaded paper or form, place the printer offline and press the UNLOAD/FORM SELECT button. This positions the top of the paper in the tractors in the base of the printer.
2.To open the case for access to the tractors, pull out on the bottom of the lower front panel of the printer to release the latch as shown below:
Opening The Latch Panel
26
