P R I N T E R C O N F I G U R A T I O N

When shipped from the factory, the Form Names will be set to “FORM 0” through “FORM 9”. This name may be changed to any combination of capital letters (A-Z), numerals (0-9), or spaces. The name may be up to 16 characters in length.

Entering a name uses the CURSOR button and either VALUE buttons. The CURSOR button will advance the cursor, a flashing block, which is used to indicate the character that is to be changed. The VALUE buttons will change the character where the cursor is currently flashing. The order of characters that may be selected is “ABCDEFGHIJKLMNOPQRSTUVWXYZ, Space, 0123456789”. Even though the name will be right justified while being entered, it will be automatically centered on the display when not in Setup Mode, so there is no need to try to center it with spaces.

Tractor Path

Tractor Path Front

Possible Values: Front, Center, and Rear

This item is only available in the FormsPro 4503se and is used to set the tractor path to be used for the currently selected form. Typically, most forms are only loaded in one tractor path and the value will be set to Front, Center, or Rear.

Automatic Cut

Possible Values: No*, Yes

Automatic Cut No

This item is only available when the optional FormsCutter is installed in the printer. When set to Yes, the printer will automatically cut each form at the perforation (based upon the Form Length setting) and eject the form into the paper basket that is installed with the FormsCutter. If set to No, the paper will exit through the top of the cutter and into the basket on the print stand. To manually cut a form or report at the end of the current page, the user can take the printer offline and press the UNLOAD button. See the FormsPro 4000se Series FormsCutter Manual for additional information.

47

Page 55
Image 55
Printek 4000se manual Tractor Path Front, Automatic Cut No