Printek 8000SE manual Bottom line of the display will show the paths, That it may be torn off

D A I L Y O P E R A T I O N

and the bottom line of the display will show the path(s).

FORM FEED:

∙ If a form is currently loaded and perhaps

	partially printed, this button will advance the
	bottom of the current form to the tear bar so
	that it may be torn off.
	∙ If a form has already been advanced to the
	tear bar, this button will advance the next
	form to the tear bar.
FORM SELECT	This button is used to access up to ten different
/UNLOAD	forms which have been previously configured
	with the Setup menus (see the chapter on Printer
	Configuration for more information).
	When this button is pressed, one of two functions
	will be performed.
	UNLOAD:
	∙ If a form is currently in position to be
	printed, this button will pull the form down
	until the top of the form is below the top of
	the tractors. In the FormsMaster 8003se
	this will also cause the tractor shuttle to
	move forward for easy access to all tractors.
	FORM SELECT:
	∙ If the form has already been pulled down to
	the tractors as described above, this button
	will cycle through all the available form
	choices. Forms which are not considered to
	be “loaded” in the tractors will flash <not
	loaded> on the bottom line of the display.
	In the FormsMaster 8003se the not loaded
	message will alternate with the tractor path
	assigned to that form. For more information,
	see the following section on “Selecting and
	Loading Forms”.

25