D A I L Y O P E R A T I O N
case of the FormsMaster 8003se this will also move the shuttle forward for easy access to all tractor paths.
3.Continue to press the FORM SELECT button until the desired form name is shown on the top line of the display. The form name will be FORM 0 through FORM 9 or the actual name of the form if the name has been set in Setup. If the desired form is not considered to be “loaded” by the printer, <Not Loaded> will flash on the bottom line of the display. In the case of the FormsMaster 8003se the not loaded message will alternate with the path(s) that this form is to be loaded in.
Loading the Form in the Tractors
4.Open the paper door on the front of the printer. This will provide access to the tractors as shown below. If your printer is a FormsMaster 8000se, only one set of tractors will be available and you may skip ahead to step 6.
FormsMaster 8003se tractors
5.Depending upon which path(s) the new form is to be placed in, you may need to tilt the front and/or center tractors forward as shown.
28
