G E T T I N G S T A R T E D
3.Lift open the paper door on the front of the printer to expose the paper feed tractors as shown in the following picture.
FormsMaster 8003se Tractors
Loading the Front Tractors
4.Open the doors on each tractor.
5.Feed the paper up through the bottom of the printer and position the holes in the edge of the paper over the pins in the left tractor while making sure that the paper will not extend above the top of the tractors. Then close the tractor door.
Note: The left tractor position is not adjustable. If it is necessary to adjust where printing begins, refer to “Aligning Print” in the “DAILY OPERATION” section of this manual.
6.Now position the paper in the right tractor in the same fashion. If necessary, the position of the right tractor may be adjusted. To do so, move the lever on the side of the tractor down to unlock the tractor and slide the tractor sideways on the shafts. If necessary, the paper guides between the tractors may be slid in either direction to accommodate the form width. Make sure that the guides are spaced evenly between the tractors.
17
