Printek 8000SE manual No Paper to Load, Too Much Paper to Unload, Selected Form is Not Loaded

D A I L Y O P E R A T I O N

Finally, place the printer back on line by pressing the ONLINE button. This will automatically load the new form and begin printing. Depending upon how the printer has been set up, the printer may start printing where it left off or it may start at the beginning of the page where the error occurred and reprint the entire page. See “Paper Out Fault Action” on page 61 for more information.

No Paper to Load

This error occurs when the LOAD button has been pressed and there is no paper or form in the tractors. Place paper in the tractors and press LOAD again.

Too Much Paper to Unload

This error occurs when the UNLOAD button has been pressed and there is paper present too far beyond the tear bar. This error serves as a warning that you may be putting forms that have already been printed on back into the printer. Tear off any printed forms past the tear bar and press UNLOAD again. This error also occurs if the LOAD button has been pressed and the current form cannot be unloaded.

Selected Form is Not Loaded

This error occurs when ONLINE has been pressed and the currently selected form is displaying <Not Loaded>. Either press LOAD to load the selected form or select a different form and then press ONLINE.

No Ribbon or Wrong Ribbon

This error occurs when the printer is attempting to go on line and cannot detect the presence of a ribbon cartridge. This may be due to the ribbon not actually being present in the printer, or the ribbon may not be installed properly.

This error may also occur when attempting to use a non-Printek brand ribbon. Before attempting to use a ribbon brand other than Printek, please read “Why Use Only Printek® Brand Ribbons” on page 10. Then if you do decide to use non-Printek brand ribbons, refer to “Ribbon Checking” on page 64.

39