Q-See QSDT8PCDP Z. Cameras, P.T.Z Control Configuration, ADD User, Protocol Setup, Delete User

ADD USER
	P.T.Z. CAMERAS	CHAPTER 8
Click Add in User Configuration to access
the Add User area.	If you are installing a PTZ camera, then the PTZ controls must be set up before operating the
	camera. You should have your PTZ camera’s manual handy when configuring and operating
Enter the user name, password, confirm	the PTZ camera for the first time. You should have the information regarding the Baud Rate,
password and select user rights, and then	Protocol and Address ready before you begin.
click OK.
PICTURE 7-16	8.1 P.T.Z CONTROL CONFIGURATION

	The PTZ settings are found in the Configuration menu. Click on the wrench icon on the
Delete User	right side of the Display Interface to enter the Configuration menu and then click on the
	PTZ menu to configure its settings.
Select the user name in User
Configuration, and click Delete, and
confirm delete.
	PICTURE 7-17

PICTURE 8-1

PROTOCOL SETUP

You can select different protocols, serial port number for P.T.Z devices.

The settings you enter here must match the setting on the PTZ camera.

Port - Users can set serial port number.
Protocol - Communication protocol of the
P.T.Z device.	PICTURE 8-2
SuperDVR supports the following protocols:
DSCP, DH-SD, Lilian, Minking, Neon, PelcoD,
PelcoP, Star, VIDO, VISCA
Address - Communication address of P.T.Z
device (ID number)

CHAPTER 8 P.T.Z. CAMERAS

48 49