Image Creation

Repeat Image—Copying a Part of an Original Image Repeatedly

This function copies a part of the original image repeatedly.

Note

❐When this function is used, the leading edge margin of 10mm, 0.4" is set on the copy paper.

❐There are three ways to specify the image of the original to be repeated as follows:

Size Input:

This function allows you to reproduce the top band of an original repeatedly down the entire

 

 

copy. You specify the width of the band (the vertical length of image) and it is repeated as many

 

 

times as will fit on the copy.

 

Number of Images:

This function also allows you to reproduce the top band of an original repeatedly down the entire

 

 

copy, but here you specify the number of image repetitions you want and the copier will deter-

 

 

mine the width of the top band.

 

Editor Area:

This function allows you to select an area of the original and reproduce it repeatedly down the

 

 

copy. The repetitions are made one below the other, and are all aligned to the right. (Only for Edit

 

 

type)

 

❐ For an explanation of entering numbers, ☛ see page 25.

 

❐ The number of repeated images that can be fit on a single sheet of copy paper is calculated automatically based upon

 

the copy paper size, copy paper direction and enlargement/reduction ratio.

 

❐ Depending on the copy paper size, copy paper direction and enlargement/reduction ratio, parts of repeated images

 

may be cut off.

 

 

❐ When using the Length key or the Editor Area key, parts of some repeated images may be cut off depending on the

Copying

values you enter.

 

 

 

 

 

 

97