Setting a Stack of Originals in the Document Feeder

Setting a Stack of Originals in the Document Feeder

You can insert a stack of originals into the document feeder. These originals are individually fed onto and removed from the exposure glass (platen glass).

Note

Some originals are unsuitable for the document feeder. See page 30.

Do not press down or hold originals after inserting them.

While originals are fed from the original table to the exposure glass (platen glass), do not pull them out.

Do not lift the document feeder until the original has been completely fed out.

1Correct any curl, fold, or crease in the originals before setting the originals.

2Make sure the Insert Original indicator is lit and the exposure glass (platen glass) is clear of origi-

nals.

TRSR050E

3Adjust the guide to the original size.

4Set the originals face up into the document feeder until the Insert Original indicator goes off.

Note

The last page should be on the bottom.

The original guide must touch the front side of the originals.

Do not stack originals above the limit mark.

1

2

1:Limit mark

2:Original guide

32