Configuring Network Settings
Assigning the machine's IPv6 address manually
•The IPv6 address assigned to the machine must not be used by any other device on the same network.
1.On the [Start] menu, click [All Programs].
2.Click [Smart Organizing Monitor for SP xxx Series].
3.Click [Smart Organizing Monitor Status].
If the machine you are using is not selected, click [Connect Printer], and then select the machine's model.
4.Click the [User Tools] tab.
5.Click [Printer Configuration].
6.Enter the access code, and then click [OK].
The default access code is "Admin". Enter "Admin" if it has not been changed. Case is significant.
7.Click the [IPv6] tab.
8.Select [Disable] in [IPv6 DHCP:].
9.Select [Enable] in [IPv6:].
10.Enter values in [Manual address:], [Prefix length:], and [Gateway:], and then click [OK].
11.Click [Close].
Wireless LAN Setup
This section explains how to configure the wireless LAN settings manually using Smart Organizing Monitor. For easy setup using WPS
•If DHCP is enabled, specify the wireless LAN settings over a wired connection, and then reestablish the connection using the wireless IP address.
Configuring the Infrastructure mode using Smart Organizing Monitor
•Ensure that the router, access point, or device equipped with a wireless LAN, etc., is turned on.
•Check the authentication method and the name of the router, access point, or device equipped with a wireless LAN (SSID/IBSS) in advance.
1.On the [Start] menu, click [All Programs].
17
