Entering Characters
The following dial buttons are used for entering characters. Press the left/right direction buttons to move a cursor. Then, modify or insert the desired characters.
Entering Alphabet
Press the [Menu] button repetitively to select character input mode. The location of alphabet letters on dial buttons is described as follows:
Table A.2 Location of Alphabet Letters on Dial Buttons
Dial | Alphabet | Dial Button | Alphabet | Dial Button | Alphabet | |
Button | ||||||
|
|
|
|
| ||
1 | Q Z | 2 | A B C | 3 | D E F | |
|
|
|
|
|
| |
4 | G H I | 5 | J K L | 6 | M N O | |
|
|
|
|
|
| |
7 | P Q R S | 8 | T U V | 9 | W X Y Z | |
|
|
|
|
|
| |
* |
| 0 |
| # |
| |
|
|
|
|
|
|
♦Press the button repetitively until the desired alphabet letter appears.
e.g.) Press the button [5] twice to enter K. Press the button [7] four times to enter S.
♦To enter another alphabet letter from the same button sequentially, enter the first alphabet letter, wait for about 3 seconds, and then press the button again.
♦Perform the following procedure to insert blank.
−Press the right direction button to insert blank.
−To insert blank between the entered characters, press the left/right direction buttons to move a cursor to a character that will be right next to the blank, and press the dial button [0] once.
♦Press the [Cancel] button to delete any characters. Press the [Cancel] button briefly to delete the character left to the cursor one by one. Press the [Cancel] button for more than 2 seconds to delete all characters left to the cursor.
