Samsung SF-430 Part, Box, Change the software paper size settings, Data, or it prints, Incorrect

Problem	Possible Cause and Remedy
Part of the	• The page layout is too complex. Simplify the page layout
printed page is	and remove any unnecessary graphics from the
blank.	document if possible.
	• The page orientation setting may be incorrect. Change
	the page orientation in the Printer Properties dialogue
	box.
	• The paper size and the software paper size settings do
	not match. Insert the correct paper into the product or
	change the software paper size settings.
	• If using a parallel cable, ensure that it is compliant with
	an IEEE-1284 rated cable.
Your product	• The printer cable might not be connected properly.
prints the wrong	Check the printer cable connection.
data, or it prints	• There may be a problem with the printer driver software.
incorrect
	Exit Windows and reboot the computer. Turn the printer
characters.
	off and then back on again.
	• If using a parallel cable, ensure that it is compliant with
	an IEEE-1284 rated cable.
Printing is too	• You may be using High or Maximum print quality. See
slow.	page 2.11. The higher the quality, the lower the speed.
	• If you are using Windows NT, the Scheduling setting may
	be set incorrectly. From the Start menu, select Settings
	and Printers. Click your printer icon with the right
	mouse button, select Properties, click the Scheduling
	tab. Then, select the desired scheduling setting from the
	available choices.
When printing	When the USB mode is set to FAST, the communication
using the USB	between the product and the computer may be poor.
connection, an	Change the USB mode to SLOW. To do so, take the
error occurs	following steps:
repeatedly	1. Press Setup on the front panel. You can see “1.SYSTEM
	SETUP” on the display.
	2. Press Enter.
	3. Press the Scroll buttons (	or	) until you see
	“USB MODE” and then press Enter.
	4. Press the Scroll buttons (	or	) to select “SLOW”
	and then press Enter to save the selection.

7.14TROUBLESHOOTING