5. Extended setup options
Label mode (valid only in fanfold setting)
Label mode is designed to prevent continuous forms labels from being peeled from the backing sheet and becoming jammed in the printer.
47 LABEL MODE
LABEL MD: NO
LABEL MD: YES
........... Set the label protect mode off.
........... Set the label protect mode on.
When the bottom edge of the label is positioned on the round surface of the platen for more than 10 seconds, the label is automatically repositioned away from the platen. When data is received by the printer, the labels are automatically positioned to the top of the next available label before printing begins. This function becomes effective when each label is equally apart and the same page length (min. 2 inches) is set for a single label.
Setting of "Paper out" detection
48 P.OUT DTCT
DETECT: PAGE END
DETECT: ANY POS
In the "ANY POS" setting, "Paper out" detection is functioning at the any position. In the case of "PAGE END":
For fanfold paper: "Paper out" detection functions near the perforation only. After the detection, the print line feed data are not executed. With this function the printing format is maintained even after the sheet change.
For cut sheet paper: "Paper out" detection does not function within the paper size. The "Paper out" detection functions when the LF is exceeded over the paper size.
When a sheet shorter than the selection sheet size is printed. the printing is made even if paper out.
Cut sheet feeder type
A function for defining the CSF configuration. The CSF type, single tray can be set when the CSF is installed.
When single is selected, the paper tray (bin 1) can be selected by the BIN key on the front control panel.
49 CSF OPTION
NOT INSTALL
CSF: SINGLE
CSF: DOUBLE
Setting of the auto-scrolling position
50 SCROLL POS.
SCROLL:ANY POS
SCROLL:TOF ONLY
Set the position for executing
In the case of "TOF ONLY" :
"ANY POS" : If the perforation is between the paper cutter and printing head position,
50
