Siemens Sitrans General Transmitter Information, Damping information, Command Description Usage

Command	Description	Usage
Number
128	Set Alarm Select	Transmitter Specific

129Adjust for Product Build-up on Sensor

130Read Failsafe Mode selection

131Return Device Config. Info.

132Write Variable Upper/Lower Limit Values

133Read Variable Upper/Lower Limit Values

134Write Keylock Value

135Read Keylock Value

138Write Simulation Timer and Value

139Read Simulation Timer and Value

140Write S.V. Units and Range Values

141Read S.V. Unites and Range Values

144Reset recorded PV min./max. values back to PV

145Return recorded PV min./max. values

150Write Analog Signalling Mode

151Read Analog Signalling Mode

152Write Digital Signalling Mode

153Read Digital Signalling Mode

154Write Analog Threshold Settings

155Read Analog Threshold Settings

156Write Digital Threshold Settings

157Read Digital Threshold Settings

160Write Delay Timers Analog Signalling

161Read Delay Timers Analog Signalling

162Write Delay Timers Digital Signalling

163Read Delay Timers Digital Signalling

General Transmitter Information

Damping information

The SITRANS LC 500 transmitter implements damping on most of the transmitter variables. The damping setting may vary from 1 (shortest value) to 10000 (longest value).

Non-volatile Memory Data Storage

The flags byte of Command #0 referenced in the Universal Command Specification document will have Bit #1 (Command #39, EEPROM Control Required) set to 0, indicating that all data sent to the transmitter will be saved automatically in the non-volatile memory upon receipt of the Write or Set Command. Command #39, EEPROM Control, is not implemented.

Appendix C

7ML19985GE01 SITRANS LC 500 – INSTRUCTION MANUAL Page 79