Chapter 1 | Quick Start |
Edit Mode
Edit
Layer 1
To edit a setting in any menu, turn the control knob to scroll to the desired setting, then press the Edit SoftKey.
In Edit mode, the cursor moves to the setting value and the SoftKey functions change to show:
Next: Store the parameter and move to next parameter for editing.
Cancel: Stop editing and return the selected parameter to its previous value.
Enter: Stop editing and save values for selected parameter.
In Edit mode, adjust the control knob to set the desired parameter value.
Spend some time navigating through the Quick Setup parameters and editing values. When you are comfortable, be sure your values for Layer 1 match those shown below.
Exit to Main
Edit
Next Layer
THICKNESS(kA) |
| RATE(A/s) | POWER( % ) | |
0.000 | 0.0 | 0.0 |
| |
My Process 1 |
|
| ||
Parameter |
| Value | Units |
|
|
|
|
|
|
Init Rate | 11.1 | A/s |
| |
| ||||
Fnl Thk | 0.101 | kA |
| |
P Term | 50 | None |
| |
I Term | 0.7 | Sec. |
| |
D Term | 0.0 | Sec. |
| |
Sensor 1 |
| O n | On/Off |
|
Sensor 2 |
| O n | On/Off |
|
Output |
| Out1 | Out1/Out2 |
|
Max. Power | 76.0 | % |
| |
Slew Rate | 10.0 | % |
| |
Material |
| Copper |
|
|
|
|
| ||
|
|
|
|
|
Quick Setup Menu
Exit to Main | Press Exit to Main to return to the main screen. |
