97
CCD-TRV101.3-856-814-21 (E,S)
Additional information / Información adicional
Cause and/or corrective actions
• Moisture condensation has occurred.
mRemove the cassette and leave the camcorder for at
least 1 hour. (p. 91)
• Reset the date and time. (p. 84)
• The cassette was ejected after you recorded on it.
mThe End Search function will not activate until you
make a new recording after reinserting the cassette.
• The POWER switch is set to CAMERA or OFF.
mSet it to VTR. (p. 23)
• The tape has run out.
mRewind the tape or use a new one. (p. 23)
• STEADYSHOT is set to OFF in the menu system.
mSet it to ON. (p. 52)
• The SteadyShot function does not work when the wide
mode is set to 16:9FULL.
• The stereo tape is played back with HiFi SOUND set to 1
or 2 in the menu system.
mSet it to STEREO. (p. 32)
• The picture has been recorded with WIND set to ON in
the menu system.
mWhen there is no wind, set it to OFF. (p. 32)
• The START/STOP MODE switch is set to 5SEC or .
mSet it to . (p. 15)
• Focus is set to the manual mode.
mSet it to autofocus. (p. 57)
• Shooting conditions are not suitable for autofocus.
mSet focus to manual mode to focus manually. (p. 57)
• There are unwanted blanks before or after the title.
mDelete them, then select . (p. 50)
• The START/STOP MODE switch is set to 5SEC or .
mSet it to . (p. 15)
• A title is displayed.
mTurn off the title. (p. 48)
Operation
Symptom
{ and 6 indicators flash and no function
except for cassette ejection works.
The date or time indicator displays bars
(--:--:--).
The End Search function does not
activate.
The tape does not move when a tape
transport button is pressed.
The SteadyShot function does not activate.
No sound or only a low sound is heard
when playing back a tape.
Excessive high-piched sound is heard.
Recording stops in a few seconds.
The autofocus function does not activate.
The title display position shifts.
The fader function does not work.

Continued to the next page