If these settings are modified, the camera settings of the NSR also need to be modified.
4 Once you have configured all the desired settings, click [Connect].
The settings are used to connect to the camera and the camera is registered once it is detected.
Caution
If the specified IP address is the same as that of an already registered camera, a warning appears and the camera cannot be registered.
Deleting a Camera
1
Click [Camera] in the tree on the left side of the window.
The Camera screen appears.
2
3
Select the camera to delete, and click [Delete] at the top right of the screen.
To delete multiple cameras, select the cameras while holding down the Shift key or Ctrl key.
The delete confirmation screen appears.
Click [OK].
The camera is deleted.
Note
When a camera is deleted, “No Camera” appears in the monitor window of the layout. With the default layout, the next camera that you register will be assigned to the open monitor window.
When a registered camera is deleted, data recorded during the registered period cannot be searched. In such a case, recorded data is not deleted. Recorded data can be deleted when the conditions for deletion from storage or data overwrite are met. For details on settings, see “Storage” under “General” of “Advanced Configuration” (page 84).
Configuring the Advanced Settings of Cameras
You can configure advanced settings such as the main, preset, mask, and motion detection settings for each camera individually.
Chapter 5 Settings 101