When using a DHCP server to configure address settings automatically
Select [DHCP].
When configuring addresses manually
(1)Select [Static].
(2)Enter the following information.
IP Address
Enter the desired IP address.
Caution
•Before you enter the desired IP address, make sure that it is not already otherwise used on the network. Entering an IP address already in use may lead to erratic operation of the unit, but no error messages appear to indicate the fact.
•Because of IP address attribution rules, setting an invalid address such as the ones below is not allowed. Example: 224.0.0.0 to 255.255.255.255
0.0.0.0 127.0.0.1, etc.
Netmask
Enter the subnet mask address.
Note
The default settings for network devices are as follows.
IP Address: 192.168.[0/1/2]*.1
Netmask: 255.255.255.0
*The settings for each of the network devices #1, #2, and #3 (only network device #1 for the
The [Monitor Model] screen appears.
9 Perform screen size settings depending on each monitor port, and then click [Next].
When two monitors are connected, clicking [Dual Head] displays the second monitor configuration screen.
Select the appropriate monitor type and resolution (pixels) for your monitor.
Notes
•The default setting for monitors is as follows.
Generic LCD Display; LCD Panel 1600×1200;
•Most monitors will operate with [Generic Monitor], but you can select [Others] as required.
Chapter 2 Initial Configuring the System | 20 |
|
|