Network Address

Enter the camera’s IP address in this text box.

This setting does not appear when configuring multiple cameras simultaneously.

HTTP Port

Enter the HTTP port number necessary to access the camera.

Timeout (sec)

Enter an access timeout for the camera in seconds.

Use Proxy

If you are using a proxy server to access the camera, select this check box. If you select this check box, configure the address and port number of the proxy server.

SNT Settings

These settings appear when the selected camera is from the SNT series. Configure settings specific to SNT models.

Specify the channel if the camera is registered as an SNT with multiple channels. Furthermore, to register the cameras of each channel, click [Add Channel] and register them as new cameras.

Camera

Select a connected analog camera.

For SNT-V304 : A camera cannot be specified.

Note

The “New Protocol 1” to “New Protocol 5” options that appear for the SNT-V704 are scheduled for future use.

Channel

Select the channel to use.

For SNT-V704 or SNT-V304:

Select from Channel 1, Channel 2, Channel 3, and Channel 4.

For SNT-V501 : Fixed to Channel 1. This cannot be modified.

Video Settings

Configure the monitor and recording settings for images captured by the camera.

Mount Angle

Configure the angle for camera images. Select from 0 degrees, 90 degrees, 180 degrees, and 270 degrees.

Caution

VMF and Video Motion Detection (Camera) do not support the 90- and 270-degree mount angles. When using VMF or Video Motion Detection (Camera), always use the 0- or 180-degree mount angles.

Video Codec

Set the video codec for the camera. Select from JPEG or MPEG 4.

FPS

Specify the image frame rate for the camera.

Resolution

Specify a resolution for images imported from the camera.

For some cameras, the resolution used will differ for NTSC and PAL. For details, refer to “Camera Resolution Details” (page 173).

Chapter 5 Settings 104