Action

Select the type of action to perform upon triggering from the pull-down list. Select from [Report By Mail], [Start Beep], [Stop Beep], [Change Monitor Layout], [Activate Alarm Out], [Deactivate Alarm Out], and [Recall Preset].

The settings that appear subsequently vary depending on the action you select here.

•When [Report By Mail] is selected

You can select whether to send a still image attachment in response to a trigger. When there is an event such as a hardware failure or system error, basic information about the error is included in the body text of the message.

E-Mail (SMTP)

The recipient cannot be set here. Use “e-Mail” on the General screen to enter a recipient address.

Caution

Configure the e-mail settings before configuring actions. If you modify the e-mail settings after configuring an action, you need to resave the corresponding action for the new settings to take effect.

Send Still Image

Select this check box to send a still image attached to the message. However, when a still image cannot be generated, no still image is attached to the message sent even if this check box is selected.

Camera

Select the camera to capture the still image.

• When [Start Beep] is selected

Duration (sec)

Specify the length of the beep in seconds.

Chapter 5 Settings 133