Note

The pre-alarm, alarm, and post-alarm periods have the following relationship.

1Pre-Alarm Period

The period of time before the alarm occurred, as set in [Duration] under [Pre Alarm].

2Alarm Period

The alarm signal is active during this period.

3Post-Alarm Period

The period of time after the alarm is stopped, as set in [Duration] under [Post Alarm].

The post-alarm period can be set as the period starting from either the point the alarm is triggered or the point the alarm ends.

4Alarm Triggered

The alarm signal was activated at this moment.

Inputs

Configure properties relating to the input source.

Sensor Input

If you want to select a sensor input name as a trigger for alarm recording, select this check box and then select a sensor input name.

You can select multiple sensor input names.

When the [Show all] check box is selected, all the sensor inputs enabled for the camera are displayed. When the check box is cleared, only the sensor inputs for the targeted camera are displayed.

The sensor input names of all cameras and the NSR are available for selection if [Enable] is set for them.

VMD (Recorder)

Select this check box to select motion detection as a trigger for alarm recording.

You must configure the motion detection settings to use this function.

Caution

When configuring a schedule for multiple cameras, unlike sensor inputs, each camera’s own motion detection is treated as an input.

Video Motion Filter

To select a VMF package as the trigger for alarm recording, select this check box and then select a VMF package.

Chapter 5 Settings 140