Camera Position

Select the camera position to configure.

Current Position

Select this option to configure settings for the current camera position.

Preset Position

Select this option to configure settings for each preset position.

If you select this option, Click [V], and select a preset from the list that appears, to move the camera to the preset position.

When the camera moves to the specified preset position, the settings for that position are enabled. The settings for one preset position cannot be used for another preset position.

Object Type

Select [Moving] or [Unattended].

The following options differ for [Moving] and [Unattended].

You can select [Moving] or [Unattended] for each screen, but not both.

xWith [Moving]

Threshold

Enter a value from 0 to 99 as the threshold for motion detection.

xWith [Unattended]

Detection Time

Enter a duration from 40 to 43,200 seconds to wait after an object stops moving before detecting non-motion and triggering an alarm.

The countdown is reset if the object starts moving again during the specified duration.

Caution

After an unattended object is detected (after the alarm occurs), another unattended object may not be detected for up to one minute.

Note

To facilitate configuration, the [Detection Time] item for object detection appears for both [Current Position] and [Preset Position], but overall only one value can be set for [Detection Time].

Area1 to Area4

Select Active or Inactive for each detection area.

Minimum Detectable Object Size

Enter a minimum size for the object to be detected. Or, use the mouse to configure the minimum size by dragging the edges of the (light blue) setting frame for minimum detectable object size. You can change the size of the frame by dragging each edge. The setting frame cannot be deleted.

Chapter 5 Settings 129