140 S100 User Guide – Rev. D – June 2005
1
SyncServer S100FCC

NOTICE AND COMPLIANCE STATEMENT

Class A

Symmetricom, Inc.
3750 Westwind Blvd.
Santa Rosa, Ca. 95403 USA
Declares that the following Model:

MODEL S100

NETWORK TIME SERVER

MODEL NO. S100

MODEL NO. S100/GPS

MODEL NO. S100/RB

MODEL NO. S100/GRB/GPS

CONFORM TO THE FOLLOWING FCC NOTICE:
This device has been tested and found to fully compliant with the limits with the FCC Part 15, Subpart B, Section
15.109 and ICES-003 Class A Limits, using the CISPR 22:1997 specifications and ANSI C63.4:1992 T est
Methods. These limits are designed to provide reasonable protection against harmful interference in a res idential
installation. This device generates, uses, and can radiate radio frequency energy and, if installed and used in
accordance with the instruction manual, may cause harmful interference to radio comm unications. However,
there is no guarantee that interference will not occur in a particular installation. If this device does c ause harmful
interference to radio or television reception, the user is encouraged to try to correct the interf erence by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the computer and receiver.
• Connect the computer into an outlet on a circuit different from that to which the receiver is connec ted.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the grantee of this de vice could void the user’s
authority to operate the equipment.
FCC Compliance Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the follo wing two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause u ndesired operation.
Note: The Model XLi is compliant with the supplied standard antenna.
I declare that the equipment specified above conforms to the above Directives and Standards.
01 August 2003 Robert Mengelberg Quality Engineer
Date Name Title Signature