There is no output to the “Mail test” field. That is because mail is tested by sending an e-mail to the address that you indicated earlier.

Click Finish.

Setup Complete dialog

Figure 3-33:Your set-up is complete

This screen verifies your configuration of the S100:

Its time source

Host name

System location

Administrator e-mail

Configuring NTP

To configure NTP, use the NTP Relationships dialog (See “NTP Relationships” on page 58). Use the dialog to view the NTP status and create the NTP associations.

IRIG-B (v.120,122,123)

Both the D-BNC Signal Breakout Cable and the optional Rubidium oscillator cable provide a Timecode Input connector. To use IRIG time code as a reference, connect the IRIG signal to the Timecode Input connector, select IRIG-B(see Figure 3-16), and click Next.

If you wish to use dial-up as a backup time source to GPS, click the checkbox next to Use dialup for backup to IRIG-B, then the Next button.

If you do not want to back up your IRIG with dial-up, leave the checkbox unselected, and click Next.

S100 User Guide – Rev. D – June 2005

45

Page 53
Image 53
Symmetricom S100 manual Configuring NTP, IRIG-B v.120,122,123