1.2.9Cooling and mechanical construction

The GenesysTM series is cooled by internal fans. At the installation, care must be taken to allow free airflow into the power supply via the front panel and out of the power supply via the rear panel. The GenesysTM power supplies have a compact and lightweight package, which allows easy installation and space saving in the application equipment.

CAUTION

Observe all torque guidelines within this manual. Over-torquing may damage

Unit or accessories. Such damage is not covered under manufacturers warranty.

1.3 ACCESSORIES

1.3.1 Included Accessories

The following accessories are delivered with the power supply:

1.3.1.1 Serial Link Cable

Serial link cable for linking power supplies by RS-485 communication.GEN/RJ45.

Cable description: 0.5m Length, shielded, RJ-45 type plugs, eight (8) contacts (P/N 15-507-201)

1.3.1.2 Hardware (delivered with power supply)

Strain Relief for AC Cord

Output terminal Shield

DB25 Programming Plug kit (AMP 749809-9)

750W Only - Power Cord

1500W Only - No Power Cord is Provided.

1500W Only Input Connector plug kit (Phoenix Contact, plug: IMC 1,5/7-ST-3,81, Header: IMC 1, 5/7-G- 3,81))

1.3.2Optional Communication Cables (See Para. 7.5)

RS-232 Cables to connect GEN to Serial Port on PC

GEN to PC (DB9)

GEN 232/9

P/N 15-507-203

GEN to PC (DB25)

GEN 232/25

P/N 15-507-204

RS-485 Cable to connect GEN to Serial Port on PC

GEN to PC (DB9)

GEN/485-9

P/N 15-507-202)

1.3.3AC cables

AC Cables are provided with 750W Model only, according to suffix in Model Number.

For 750W GenesysTM power supplies:

Part No.

Market

Description

NC301

USA

13A 125V, unshielded, 2m typical length, with IEC320 connector on one end and NEMA-

(GEN/U)

 

5-15P connector on the other end.

NC302

Europe

10A 250V, unshielded, 2m typical length, with IEC320 connector on one end and INT’L 7

(GEN/E)

 

standard VII, dual earthing.

NC303

General

10A 250V, unshielded, 2m typical length, with IEC320 connector on one end and unter-

(GEN/O)

 

minated stripped wires on the other end. Use the cable only with plug approved by the

 

 

national safety standards of the country of usage.

NC305

Japan

13A 125V, unshielded, 2m typical length, with IEC320 connector on one end and Japan

(GEN/J)

 

type plug on the other end.

NC306

UK

10A 250V unshielded, 2m typical length, with IEC320 connector on one end and UK type

(GEN/GB)

 

plug on the other end.

For 1500W GenesysTM power supplies the recommended AC cable (customer supplied) is:

25A 250V, 3x12AWG, outer diameter: 9-11mm, rated 60°C min., 3m max. length. Add a non-locking plug approved by the national safety standards of the country of usage.

8

83-507-013 Rev. D

Page 16
Image 16
TDK 1500W, 750W technical manual Accessories