Tektronix 480X user manual Connecting to a single computer, LocalTalk Tatus

Getting Set Up 2

Connecting to a single computer

Follow these steps if you are connecting the printer directly to your computer via LocalTalk:

1.Make sure that the printer is turned off before making any LocalTalk connections.

2.Connect the short cable of a LocalTalk connector to your computerÕs LocalTalk port.

3.Connect the short cable of a second LocalTalk connector to the printerÕs LocalTalk port.

4.Connect a LocalTalk cable between the two LocalTalk connectors you have just attached to your computer and your printer.

LocalTalk®

tatus

C A U T I O N

This printer is set

to 115 VAC

PHASER 480 MODEL 4688	Serial
	(RS-232)	1 2 3 4	5 6	7 8	9
Ethernet Address		*	*	*	*

Not Installed
Ethernet®	SCSI
	LocalTalk®
	Status

*See User Manual

Parallel

2 3

4

8849-19

Note If your LocalTalk connectors require an external terminator (see the illustration on the previous page), make sure that the last device on either side of the network has a terminator inserted into its LocalTalk connector.

If you have no other connections to make, read ahead to ÒTurning on the printerÓ on page 2-19.

User Manual 2-17