ValidatorTM Running Manual Tests |
Performing a Bit Error Rate Test
A Bit Error Rate Test (BERT) sends data packets from the main unit to the remote, measures speed and errors and correlates this to a PASS or FAIL result. This test can only be run from end to end on a single cable, it cannot be run through an Ethernet hub or switch.
1.From the Data Manual Tests screen, select the BERT Test button. (Figure 5.9)
2.Using the drop down dialog box, select an Ethernet speed of 1 gigabit or 100 Megabits. Press Accept
3.Select the number of bits to transfer from the drop down dialog box. Press Accept.
4.Press the Test button to begin the run. The % Complete will advance as the test proceeds and any errors will be reported as the % Completed is updated. A Pass or Fail will be displayed at the end of the test based on the industry standard of not more than one error in 10 Gigabits transferred.
BERT Test Untitled1.job
| 2005 Aug 25 | |
100% | 10:53:01 | VALIDATOR |
Ethernet Speed: | 1 Gbit/s |
Bits to Transfer:
Test Rate:
%Completed:
Error:
10 Gbits 
Figure 5.9 Bit Error Rate Test
73
