TiVo SDOC-00091-002 manual Resetting the DVR Switch

5 Settings

By default, all DVRs and remote controls have a Remote Address

of “0” (zero). A remote control with a Remote Address of “0” will control any DVR, even one with an assigned code. A DVR set to “0” will respond to any remote control, even one with an assigned code. This prevents you from becoming accidentally “locked out” of controlling your DVRs.

DVR #2 and cover the plastic window of DVR #1. Finally, go to the System Information screen of DVR #2, and press the DOWN arrow until you see Remote Address displayed.

8.Move the DVR SWITCH to 2. Repeat steps 4 and 5, above. Assign the number “2” to DVR #2, then press the TiVo button to go to TiVo Central.

Now when you set the DVR SWITCH to 1, it will only control DVR #1—and when you set it to 2, it will only control DVR #2.

Resetting the DVR SWITCH

1.Move the DVR SWITCH to 1.

2.Press and hold the PAUSE and TiVo buttons simultaneously for about three seconds, until the red light at the end of the remote control comes on and remains steady.

3.Using the number buttons on the remote control, enter 0 (zero). The red light at the end of the remote control will flash to indicate that the DVR SWITCH (either 1 or 2) is reset.

4.To complete the reset, move the DVR SWITCH to 2 and repeat steps 2 and 3.

54