Toshiba IPE002Z instruction manual Introduction, Handling in general, Network control

E6581741

Introduction

Thank you for purchasing the “EtherNet/IP™ - Modbus® TCP option (IPE002Z)” for TOSVERT VF-MB1/S15 inverter. Before using EtherNet/IP™ - Modbus® TCP module, carefully read this function manual in order to completely and correctly utilize its excellent performance.

This option needs the option adaptor to connect VF-S15 which type form is SBP009Z. Please match here and buy it when SBP009Z is not at hand yet.

After reading this function manual, please keep it handy for future reference.

For details of its general handling, see an instruction manual attached with the option unit.

-TOSVERT VF-MB1 Instruction Manual ························································· E6581697

-TOSVERT VF-S15 Instruction Manual ·························································· E6581611

-TOSVERT VF-MB1/S15 communication option Precautions Manual··········· E6581739

-TOSVERT VF-MB1 Communication Function Instruction Manual················ E6581726

-TOSVERT VF-S15 Communication Function Instruction Manual················· E6581913

EtherNet/IP™ is a trademark of ControlNet International, Ltd.

Modbus® TCP is a registered trademark of AEG Schneider Automation International S.A.S.

Handling in general

		Warning
		Do not connect or disconnect a network cable while the Inverter power is on.
Prohibited		It may lead to electric shocks or fire.
		See the instruction manual attached with the option unit for cautions the handling.
Mandatory		Otherwise, it may lead to electric shocks, fire, injuries or damage to product.
	Network control
		Warning
		Do not send the value out of the valid range to objects and attributes.
Prohibited		Otherwise, the motor may suddenly start/stop and that may result in injuries.
		Use an additional safety device with your system to prevent a serious accident due to the
Mandatory		network malfunctions. Usage without an additional safety device may cause an accident.

Caution

Mandatory

Set up “Communication error trip function (see below)” to stop the Inverter when the option unit is deactivated by an unusual event such as tripping, an operating error, power outage, failure, etc.

-Network Time-Out, Inverter operation at disconnection, Preset speed operation selection

(Refer to "3.2.3 Network error detection (c100 - c103, c523)" for details)

Deactivated the option module may cause an accident, if the “Communication error trip function” is not properly set up.

Make sure that the operation signals are STOP before resetting Inverter’s fault. The motor may suddenly start and that may result in injuries.

Notes on operation

Notes

When the control power is shut off by the instantaneous power failure, communication will be unavailable for a while.

The Life of EEPROM is approximately 100,000 times. Avoid writing a command more than 100,000 times to the same parameter of the Inverter and the option module.

--11--