Toshiba IPE002Z instruction manual Emergency stop No emergency Stop status, Standby Initialization

E6581741

3.2.4.7. fd01 (Inverter operating status 1)

bit	Function	0	1	Note
0	Failure FL	No output	Under in	-
			progress
				Trip status includes rtry and
1	Failure	Not tripped	Tripped	the trip retention status are also
				regarded as tripped statuses.
2	Alarm	No alarm	Alarm issued	-
3	Under voltage (moff)	Normal	Under voltage	-
				THR1: pt = setting value, vl,
4	Motor selection (1 or 2)	Motor 1 (THR1)	Motor 2 (THR2)	vlv, vb, thr
	(THR 2 selection)			THR2: pt = 0, f170, f171,
		PID control	PID control	f172, f173
5	PID control off			-
		permitted	prohibits
	Acceleration/deceleratio	Acceleration/dec	Acceleration/dec	AD1: acc, dec
6	n pattern selection (1 or	eleration pattern	eleration pattern	AD2: f500, f501
	2)	1 (AD1)	2 (AD2)
7	DC braking	OFF	Forced DC	-
			braking
8	Jog run	OFF	Jog run	-
9	Forward / reverse run	Forward run	Reverse run	-
10	Run/stop	Stop	Run	-
11	Coast stop (ST = OFF)	ST=ON	ST=OFF	-
12	Emergency stop	No emergency	Emergency	-
		stop status	stop status
				Standby: Initialization
				completed, not failure stop
13	Standby ST=ON	Start-up process	Standby	status, not alarm stop status
				(moff, ll forced stop),
				ST=ON, and RUN=ON
				Standby: Initialization completed,
14	Standby	Start-up process	Standby	not failure stop status and not
				alarm stop status (moff, ll
				forced stop)
15	(Reserved)	Undefined		-

Note: Don’t use the reserved bit for the judgment.

3.2.4.8. fd00 (Output frequency)

The current output frequency is read into 0.01Hz of units and by the hexadecimal number. For example, when the output frequency is 80Hz, 0x1F40 (hexadecimal number) are read.

Since the minimum unit is 0.01%,

0x1F40 (Hex.) = 8000(Dec.) * 0.01 = 80 (Hz)
Also about the following parameters, these are the same as this.
- fd22 (Feedback value of PID)	Unit: 0.01Hz
- fd16 (Estimated speed)	Unit: 0.01Hz
- fd29 (Input power)	Unit: 0.01kW
- fd30 (Output power)	Unit: 0.01kW

- 18 -