
|
| Hardware and system checklist | |
|
|
| |
| Problem | Procedure |
|
| A CONNECT display is | Check the error control setting in your communi- |
|
| quickly replaced by | cations application. | |
| NO CARRIER | You can also use the AT\N command. Refer to | |
|
| ||
|
| the chapter on AT commands in online help files | |
|
| for Appendix C, AT Commands. | |
|
|
|
|
| Character display | In data transmission, make sure the parity bit | |
| becomes garbled | and stop bit settings correspond with those of | |
| during a | the remote computer. | |
| communication | Check the flow control and communication pro- | |
|
| ||
|
| tocol. | |
|
|
|
|
| You cannot receive | Check the rings before auto answer setting in an | |
| an incoming call | incoming call your communications application. | |
|
| You can also use the ATS0 command. Refer to | |
|
| the chapter on | |
|
| Appendix D, | |
|
| If problems persist, contact your dealer. | |
|
|
|
|
Standby/Hibernation
Problem | Procedure |
The system will not | Is Windows Media™ Player open? The system |
enter Standby/Hiber- might not enter Standby/Hibernation, if Windows
nation | Media Player is either playing a selection or fin- |
| ished playing a selection. Close Windows Media |
| Player before you select Standby/Hibernation. |
| If problems persist, contact your dealer. |
|
|
TROUBLESHOOTING