Notes for Users in Australia and New Zealand
Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid Austel permit. This modem has been designed to specifically configure to ensure com- pliance with Austel standards when the country/region selection is set to Austra- lia. The use of other country/region setting while the modem is attached to the Australian PSTN would result in you modem being operated in a
To set the country/region permanently to Australia, enter the following command sequence:
AT%TE=1
ATS133=1
AT&F
AT&W
AT%TE=0
ATZ
Failure to set the modem to the Australia country/region setting as shown above will result in the modem being operated in a
Notes for use of this device in New Zealand
❑The grant of a Telepermit for a device in no way indicates Telecom accep- tance of responsibility for the correct operation of that device under all oper- ating conditions. In particular the higher speeds at which this modem is capable of operating depend on a specific network implementation which is only one of many ways of delivering high quality voice telephony to cus- tomers. Failure to operate should not be reported as a fault to Telecom.
❑In addition to satisfactory line conditions a modem can only work properly if:
a/ | it is compatible with the modem at the other end of the call and |
b/ | the application using the modem is compatible with the application at |
| the other end of the call - e.g., accessing the Internet requires suitable |
| software in addition to a modem. |
❑This equipment shall not be used in any manner which could constitute a nuisance to other Telecom customers.
xi
