Toshiba MA-1650-4 Condition Required for Programming Operations, Mode Lock SET, Line No. ST

6. PROGRAMMING OPERATIONS EO1-11110

6.5 CONDITION REQUIRED FOR PROGRAMMING OPERATIONS

6.5CONDITION REQUIRED FOR PROGRAMMING OPERATIONS

At the top of each programming operation a “CONDITION” is given. Unless the register satisfies this condition, the programming operations will not be allowed.

There are two types of conditions:

“Any time outside a sale”

It means that the programming operation is allowed when a sale is finalized before going into any other sale entry.

“After ...Reset”

It means that the designated reset report must be taken before entering the programming operation. And an error will result if the operation is attempted without taking the report. However, the words “After ... Reset” do not necessarily mean “immediately after ...”.

When the designated reset report has already been taken and then some operations are performed in the SET, X, or Z mode, the condition “After ... Reset” is still satisfied and the programming operation is still allowed.

On the contrary, when the designated reset report has been taken but then some sales data relating to that report’s output data are entered in the REG, MGR, or - mode, the programming operation will no longer be allowed and the same reset report must be taken.

Thus the condition “After ... Reset” indicates that all the sales data relating to the report data must be zero (except non-resettable memory data). Because of this “CONDITION” requirement, the report data will be protected from any inconsistencies of sales data entered in the period from a resetting of the report to another resetting of the same report next time.

6.6STORE NAME/MESSAGE AND COMMERCIAL MESSAGE PROGRAMMING (Submode 1)

CONDITION	Any time outside a sale
OPERATION	Mode Lock: SET

Repeat for another line.

1 [@/FOR]			Line No. [ST]		(For sequentially programming
.	.
. .	. .				lines, the line number
Submode No.			1 to 7 or 5 to 7		specification can be skipped.)
	(See NOTE 2 on the next page.)
		Character Entries		[ST]
		max. 24 characters/line		. .
		(See CHARACTER		.
				To complete
		ENTRIES at the beginning
				this line
		of this chapter.)

[AT/TL]

. . .

To complete this programming operation

NOTES: 1. For each line, a maximum of 24 regular-sized characters or 12 double-sized characters may be entered. A combination of both types is also available.

6-8