Toshiba MA-1650-4 Programming Operations Common with Standalone ECR Level, Programming JOB List

5. PROGRAMMING OPERATIONS EO1-11110

5.1PROGRAMMING OPERATIONS COMMON WITH STANDALONE ECR LEVEL

5.PROGRAMMING OPERATIONS

The system should be programmed fully by your local TOSHIBA TEC representative at the time of delivery according to the user’s requirements so that daily operations can immediately start. However, some data must be added or changed daily or in a longer period. Since the volume of programming contents for the system is too large, this chapter and the following two chapters are provided as guide lines of the user’s daily programming and maintenance operations. If there are any unclear points or program data other than listed here must be changed or added, please contact your TOSHIBA TEC representative. Please also note that some programming operations introduced in the Standalone Level are modified or not available on in-line terminals.

5.1PROGRAMMING OPERATIONS COMMON WITH STANDALONE ECR LEVEL

The following is the table of programming operations which are introduced in the Manager’s Guide for the Standalone Level and can be operated on in-line terminals as well, with the Submode No. and operation sequence unchanged. However, on in-line terminals, these are usually operated on the Master Terminal only and down-line-loaded (DLLed) to all the Satellite Terminals. Therefore, if any program data is changed, a DLL is further necessary to load the new data (after the change) to all the Satellite Terminals (to be described in Chapter 5).

PROGRAMMING JOB LIST

Master: Programming is available on the master terminal

(when the [RTR] key is turned on or the INLINE lamp is on).

Satellite: Programming is available on the master terminal

(when the [RTR] key is turned off or the INLINE lamp is off), the backup master terminal and the satellite terminal.

O: Available

Submode	Programming Job	Terminals
No.		Master	Satellite
1	Store Name/Message, Commercial Message, Footer Logo Message	O	O
	Programming
2	Cashier Code and Name Programming	O
4	PLU Table Programming	O
5	Time Setting or Adjustment	O	O
6	Date Setting or Adjustment	O	O
8	Amount Limit Setting for Function Keys	O	O
15	Customer File Code (Check Track No.) and Name Setting	O
20	Salesperson Code and Name Programming	O
25	Link PLU Table Programming	O
26	Tare Table and General Unit Weight Setting	O
27	PLU Preset-code Key Setting	O	O
31	Display Message Programming	O	O
35	Negative Amount Key Limit Amount Setting	O
40	PLU Price Dollar Discout/Extra Change Amount Setting	O
No	Department Preset Price Setting or Changing	O
Sub-	PLU Preset Price Setting or Changing, When Package Quantity Changing	O
mode	% + and % - Preset Rate Setting	O	O
	Preset Rate Setting for Selective Itemizers	O	O
	Foreign Currency Exchange Rate Setting	O
	Tax Table Programming	O
	GTS Rate Setting	O
	Store/Register No. Setting	O	O

5-1