Toshiba MA-1650-4 owner manual Customer File Read, # → File Code @/FOR → AT/TL

4. READ AND RESET REPORTS

EO1-11110

4.2 IN-LINE REPORTS

TABLE OF IN-LINE REPORT OPERATIONS (continued)

RTR Declaration: ON

	Report Name	Mode			Key Operation
		Lock
CUSTOMER FILE READ
(for Check Track Memory type only)
•	All Files Read	X	15	[AT/TL]
•	All Files Reset	Z
				[#] → Zone-start File Code
•	Zone Files Read	X	15
•	Zone Files Reset	Z	[@/FOR] Zone-end File Code [AT/TL]
•	Individual File Read	X	15	[#] → File Code [@/FOR] → [AT/TL]
•	Zero-balance Files Read	X	15 [#] → 0		[AT/TL]
•	Credit-balance Files Read	X	15 [#] → 1		[AT/TL]
•	Debit-balance Files Read	X	15	[#] → 2	[AT/TL]

NOTE: When the “Process Report” is marked, the report can only be taken after taking another report which consolidates the corresponding data to be based on. For further details, see the table and descriptions below.

PROCESS REPORTS AND BASE REPORT DATA

The following table shows which process reports are available after which report data collections.

Reports Collection Required before Process
Report takings	Process Reports available
(CONSOLIDATION MEMORY CAPTURE: NOTE 1)
All Department Read Daily	Individual Department Read Daily
or
All Department Reset Daily
All Department Read GT	Individual Department Read GT
or
All Department Reset GT
Any of the following PLU reports (NOTE2)	Individual PLU Read Daily
	Inactive PLU Read Daily
All PLU Read Daily
Zone PLU Read Daily
All PLU Reset Daily
Zone PLU Reset Daily
Any of the following PLU reports (NOTE2)	Individual PLU Read GT
	Inactive PLU Read GT
All PLU Read GT
Zone PLU Read GT
All PLU Reset GT
Zone PLU Reset GT

NOTES: 1) CONSOLIDATION MEMORY CAPTURE: When an in-line read or reset report is taken on the Master Terminal, the consolidated data is automatically stored in the Consolidation Memory of the Master Terminal. The consolidated data stored there is not only used as the data for a Process Report but also sent to the PC by a command from the PC when a PC is connected.

2)The process reports will be outputted based on the report data previously collected. For example, when an “Inactive PLU Read” report is taken after a “Zone PLU Read”, only the inactive PLUs in the designated zone will be printed on the Inactive Read Report. (Only when the PLU is in a local file, a process report is printed. In this case, collection of data is required beforehand.)

4-6