4.19 Display Assembly | 4 Replacement Procedures |
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to the figures in the preceding section.
1.Seat the display assembly taking care not to crush to the LCD display cable or wireless LAN antenna.
2.Feed the wireless LAN antenna through the system board into the wireless LAN compartment.
3.If a wireless LAN card is installed, remove the wireless LAN compartment cover and attach the ends of the wireless LAN antenna to the card. The black antenna cable should be attached to the connector nearer the rear side of the computer, the white antenna cable to the connector closer to the front panel.
4.Secure the hinges with two M2.5⋅6 screws. Use the same screw to secure the display cable to the left side hinge.
5.Attach the display cable to its connector on the system board.
6.Seat the hinge cover and secure its
7.Secure the hinge cover with one M2⋅4 screw at the rear of the each hinge.
8.Secure the display assembly with two M2.5⋅6 screws on the I/O cover.
Satellite |
