Toshiba RAS-10YKV-E, RAS-13YKV-E, RAS-10YAV-E, RAS-13YAV-E service manual

No. Part name		Procedure	Remarks
V Fan motor	1) Perform work of item 1 of Q and R.
	2)	Remove the flange nut fixing the fan motor and	Fan motor
		the propeller.
		• Flange nut is loosened by turning clockwise.	Propeller fan
		(To tighten the flange nut, turn counterclock-
		wise.)
	3)	Remove the propeller fan.
	4)	Disconnect the connector for fan motor from the
		inverter.
	5)	Remove the fixing screws (3 pcs.) holding by
		hands so that the fan motor does not fall.
			Flange nut
W Compressor	1) Perform work of item 1 of Q and R, S, T, U.
	2)	Extract refrigerant gas.
	3)	Remove the partition board.
		(ST1TØ4 x 10 l 2 pcs.)
	4)	Remove the sound-insulation material.
	5)	Remove terminal cover of the compressor, and
		disconnect lead wire of the compressor thermo.
		and the compressor from the terminal.
	6)	Remove pipe connected to the compressor with	Partition	Valve
		a burner.	board	clamping
	7)	Remove the fixing screw of the bottom plate and		plate
				Compressor
		heat exchanger. (ST1TØ4 x 10 l 1 pc.)
	8)	Remove the fixing screw of the bottom plate and		thermo.
		valve clamping plate. (ST1TØ4 x 10 l 2 pcs.)		Compressor
	9)	Pull upward the refrigeration cycle.
	10) Remove nut fixing the compressor to the
		bottom plate.
X Reactor	1) Perform work of item 1 of Q, and S.			Reactor
	2)	Remove lead wires clung in holder on the
		partition board.
	3)	Remove screws fixing the reactor.
		(ST1TØ4 x 10 l 2 pcs.

– 65 –