Toshiba RAV-SM802UT-E 2 4 1, 110, <Contents>, <Procedure>, Push th e temperature setup

12-1-3. Monitor Function of Remote Controller Switch

nCall of sensor temperature display

<Contents>

Each sensor temperature of the remote controller, indoor unit, and outdoor unit can become known by calling the service monitor mode from the remote controller.

<Procedure>

1 Push CL + TEST buttons simultaneously for 4 seconds or more to call th e service monitor mode.

The service monitor goes on, the master indoor unit No. is displayed, and then temperature of the item code 00 is displayed.

2 Push th e temperature setup /	buttons to select th e sensor No. (Item code) of th e sen-
sor to be monitored.

The sensor numbers are described below:

SET DATA
UNIT	No.
R.C.	No.

TEMP. ON / OFF

2

4

1

	TIMER SET	FAN	MODE
	TIME	SWING/FIX	VENT
FILTER
RESET TEST	SET CL	UNIT

3

		<Operation procedure>
		1	2		3		4
				Returned to usual display
	Item code	Data name						Item code	Data name
	00	Room temp. (control temp.) *1						60	Heat exchanger temp. TE
								61	Outside temp. TO
Indoor	01	Room temp. (remote controller)				Outdoor
								62	Discharge temp. TD
	02	Room temp. (TA)
unit data						unit data
								63	Suction temp. TS
	03	Heat exchanger temp. (TCJ)
								64	—
	04	Heat exchanger temp. (TC)
								65	Heat sink temp. THS

*1 Only master unit in group control

3

4

Th e temperature of indoor units and outdoor unit in a group control can be monitored by push ing UNIT button to select th e indoor unit to be monitored.

TEST

Push ing button returns th e display to usual display .

– 110 –