Toshiba RAV-SM802UT-E, RAV-SM1102UT-E Last push priority, Center, Operation Prohibited

No.	Item		Outline of specifications			Remarks
14	Central control	1)	Setting at the central controller side enables to select
	mode selection		the contents which can be operated on the remote
			controller at indoor unit side.
		2)	RBC-AMT31
			[Last push priority] :		(No display)
			The operation contents can be selected from both
			remote controller and central controller of the indoor
			unit side, and the operation is performed with the
			contents selected at the last.
			[Center] :		[CENTER] goes on.
			Start/Stop operation only can be handled on the remote
			controller at indoor unit side.
			[Operation Prohibited] :		[CENTER] goes on.
			It cannot be operated on the remote controller at indoor		In a case of wireless type, the
			unit side. (Stop status is held.)		display lamp does not change.
					However, contents which can
					be operated are same.
					The status set in [CENTER]/
					[Operation Prohibited] mode is
					notified with the receiving sound
					“Pi, Pi, Pi, Pi, Pi” (5 times).
15	Energy-save	1)	Selecting [AUTO] mode enables an energy-saving to be
	control		operated.
	(By connected	2)	The setup temperature is shifted (corrected) in the
	outdoor unit)		range not to lose the comfort ability according to input
			values of various sensors.
		3) Data (Input value room temp. Ta, Outside temp. To, Air
			volume, Indoor heat exchanger sensor temp. Tc) for 20
			minutes are taken the average to calculate correction
			value of the setup temperature.
		4)	The setup temperature is shifted every 20 minutes, and
			the shifted range is as follows.
			In cooling time : +1.5 to –1.0K
			In heating time : –1.5 to +1.0K
16	Louver control	The louver angle is displayed setting 0° as “Full close”.
						Full close
	1) Louver
	position
		1)	In the initial operation after power-ON, the position is
			automatically controlled according to the operating			0˚
			status (COOL/HEAT).
				Cooling		Heating

45˚ 103˚

2)After then a louver position is stored in the microcomputer every time when position is operated on the remote controller, and the louver operates at the position stored in memory in the next operation and after.

*If the operation mode has been changed from COOL to HEAT, from HEAT to COOL, or the power has turned off, the stored louver position is cleared and the status returns to one in item 1).

2) Air direction	1)	When pushing [LOUVER] button during operation, the louver starts swinging.
adjustment	2)	When the louver has arrived at the desired position, push [LOUVER] again.
(Swing		The louver stops at that position.
operation)

– 66 –