Toshiba RAV-SM562UT-E, RAV-SM1102UT-E, RAV-SM1402UT-E, RAV-SM802UT-E 123, ‡ Drain pan 1. Detachment

No. Part name Procedure Remarks

‡Drain pan 1. Detachment

1)Perform works of items 1 of •, 1 of ‚, 1 of ƒ and 1 of „.

2)Remove clamps of the lead wires con-

nected to the following connectors of the control P.C. board.

	CN34 : Float switch (3P: Red)
	CN68 : Drain pump (3P: Blue)
	CN101 : TC sensor (2P: Black)
	CN102 : TCJ sensor (2P: Red)	Screws fixing earth lead wires
	CN333 : Power supply of fan motor
	(5P: White)
	CN334 : Position detection of fan motor	Drain cap
	(5P: White)
NOTE :
Remove the connector by releasing locking
of the housing.
3)	Remove screws fixing earth lead wire in
	the electric parts box. (Ø4 × 6, 2 pcs.)
4)	Remove indoor/outdoor inter-unit cable
	and remote controller cable of the
	terminal block.
5)	Remove screws fixing the electric parts
	box. (Ø4 × 10, 5 pcs.)
6)	Remove screws fixing the bell mouth.
	(Ø4 × 10, 6 pcs.)	Screws fixing drain pan
7)	Remove the drain cap, and drain water
	accumulated in the drain pan.

NOTE 1 :

When removing the drain cap, be sure to prepare a bucket to catch the drained water.

NOTE 2 :

Thermal insulator is adhered to the drain cap. Be careful not to peel off the insulator. If the insulator has been peeled, adhere it with double-face tape, etc. as before.

8)Remove screws fixing the drain pan. (Ø4 × 8, 4 pcs.)

2.Attachment

1)Fix the parts, drain cap, drain pan, bell mouth, and electric parts box succes- sively to their original positions.

2)Connect connectors, earth lead wire, indoor/outdoor inter-unit cable, and remote controller cable which have been disconnected in the above item 1 as before.

– 123 –