Toshiba RAV-SM2804AT8-E, RAV-SM2804AT8ZG-E, RAV-SM2244AT8ZG-E 115, Detachment, Attachment

No. Part name Procedure Remarks

5 Inverter	1. Detachment	Remove the fan motor lead wire
assembly	1) Carry out the operation in 1. of Q, 1. of Rand
		from the cord clamp.
	1. of T above.	Fan-IPDU board
	2) Remove the connectors connected to the fan motor
	relay board and the Fan IPDU board, the connector
	connected to other components from the control	Cut the
	board
		banding band
	(Interface board).
	CN600 : TS sensor (3P: White, tube: Gray)	Discharge port
	CN601 : TE sensor (2P: White, tube: Blue)	cabinet

CN602 : TO sensor (2P: Orange, tube: Black)

CN603 : TD sensor (3P: White, tube: Red)

CN604 : TL sensor (2P: White, tube: White)	Screws
CN606 : Presure sensor (4P: White)	Fan motor	Interface
CN609 : Case thermo. (2P: Blue)	relay board	board
CN690 : High poressure switch (3P: Green)	Water-proof sheet (rubber sheet)
CN700 : 4-way coil (2P: Yellow)
		Sound-insulation board
CN702 : 2-way valve coil (3P: White)
		(upper)

CN710 : PMV coil 1 (6P: White)

CN711 : PMV coil 2 (6P: White)

• Fan IPDU board

CN750 : Outdoors fan motor (3P: White)

Cut the banding band and remove connector connected from fan motor to fan motor relay board.

• Fan motor relay board

CN08 : Outdoors fan motor (3P: White)

∗Remove connectors after unlocking housing

section Compressor lead

3) Remove the screw (1 position) fixing the discharge port cabinet.

4)Cut bundling band fixing various lead lines to inverter assembly.

5)Remove water-proof sheet (rubber sheet) and

	sound-insulation plate (upper).	Case thermostat
6)	Remove terminal cover of compressor and remove
	compressor lead.	Inverter assembly
7)	Pull up the inverter assembly at upper side to
	remove hook of partition plate (rear left part).	Hook
		Hook sectio

2. Attachment
1) Mount the inverter assembly on the partition plate.		Partition plate
			Inverter
	CAUTION
			assembly

When mounting the inverter assembly on the partitioning plate, ensure proper mounting of the hook (rear left part) with partitioning plate.

2)Mount the individual components in the opposite procedure to that during detachment.

– 115 –