3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
3.2 Executing the Diagnostic Test Toshiba MS-DOS is required to run the Diagnostic Test Program. To start the Diagnostic
Test Program, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive and turn on the computer while
pressing U key.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
1.Repair Main (T&D)
2.Repair initial config set
Enter a choice = 1
To execute Repair Main (T&D), select “1.Repair Main (T&D)” with ↑ or ↓ key and
press Enter key.
To execute Repair initial config set, select “2.Repair initial config set” with ↑ or ↓
key and press Enter key.
The followings are described on the Repair Main (T&D). The Repair initial config set
is described in section 3-30.
TECRA M2 Maintenance Manual (960-468) 3-3