Toshiba tecra m2 - page 270

4 Replacement Procedures 4.18 RGB harness holder/RGB board/Modem jack
Installing the RGB harness holder/RGB board/Modem jack
To install the RGB harness holder/RGB board/modem jack, follow the steps below and refer
to figure 4-34 to 4-36.
1. Connect the RGB cable to the connector PJ5620 on the RGB board.
2. Install the RGB board while inserting the RGB connector to the slot.
3. Secure the RGB board with the following screw.
• M2.5×2.8B FLAT HEAD screw ×1
4. Install the modem jack to the slot.
5. Connect the modem cable to the connector PJ3001 on the system board.
6. Stick the glass tape.
7. Install the RGB harness holder while hooking the front latches.
8. Secure the RGB harness holder with the following screw.
• M2.5×4B FLAT HEAD screw ×1
4-56 TECRA M2 Maintenance Manual (960-468)