Toshiba tecra m2 4.13 Wireless LAN board

4 Replacement Procedures 4.13 Wireless LAN board
4.13 Wireless LAN board
Removing the Wireless LAN board
To remove the wireless LAN board, make sure the computer is in boot mode and powered
off, follow the steps below and refer to figures 4-25.
NOTE: The wireless LAN board is an option in some models. This computer supports
four types of wireless LAN board (802.11/b, 802.11a/b, 802.11b/g or 802.11a/b/g
combo).
CAUTION: Do not try to remove the wireless LAN board with the computer turned on.
The computer or the wireless LAN board can be damaged. Do not touch the
connectors on the wireless LAN board module on the computer. Debris on
the connectors may cause wireless LAN board access problems.
1. Disconnect the wireless LAN antenna cables (black and white) from the wireless
LAN board using an antenna coaxial cable disconnector.
Wireless LAN antenna cable
(
black
)
Latch
Wireless LAN board
Wireless LAN antenna cable (white)
Latch
Figure 4-25 Removing the wireless LAN board
4-40 TECRA M2 Maintenance Manual (960-468)